Note that this parts list is for the simple resistor type driver that I used to make
I do not make this type of driver now
See parts list #2 on the main bike lights page for part list I currently use to make the Marwi SSC P7 LED lights
Click on the image for a larger image
Parts List for Marwi to SSC P7 conversions
1 - 34.8mm glass lens
1 - Machined Marwi light body
1 - 35mm machined reflector
1 - Marwi SSC P7 heat sink with 2 mounting screws
1 - SSC P7 LED
1 - 5/16" grommet
1 - Rubber Tail cap, your choice of color
1 - Resistor based current limiter board set
2 - 1.3ohm current limiting resistors
2 - Clicky switches (So you can do the double contact mod)
1 - Foot each Black and Red Teflon wire
(You only need a couple inches of each color. You will have some extra for your next project)
3 - feet of Red/Black 18 gauge stranded Zip Wire
1-Set of Anderson PowerPole connectors
1-foot of 1/4" diameter heat shrink for power wires
(You only need a couple inches. You will have some extra for your next project)
A couple short pieces of wire
18ga solid core for the battery board hookup
22ga solid core for the short switch board jumper wire
You may also need a Marwi Helmet or Handlebar mount and the nylon Marwi mounting kit.
This list does not include batteries or chargers.
The Tube amp Library of information
Click the link above for Tube amp info, Schematics, Board building information, Projects, Mods, Transformer diagrams, Photo's, Sound clips.
There are hundreds of pages of Tube amp information on my library page.
Please visit my Tube Amplifier Forum
Here's the place you can go to ask tube amplifier questions.
You will find a large community of friendly amp builders at the link above.